Upgrading everyday security Commpact Manuale Utente Scaricare il pdf (Pagina 35)

c Select the appropriate virtual wire or port group.

d Click OK.

9 Select the connectivity status for the interface.

In Configure Subnets, click the Add (

) icon to add a subnet for the interface.

In Add Subnet, click the Add ( ) icon to add an IP address.

12 Type the IP address.

You must add an IP address to an interface before using it on any feature configuration.

13 Click OK.

14 Type the subnet prefix length.

15 Click OK and then click OK again.

16 Click Next.

The Default Gateway page appears.

Configure HA for Logical Router

Enable or disable HA.

If you selected Enable HA on the Name & Description page, complete the Configure HA parameters

section. NSX Edge replicates the configuration of the primary appliance for the standby appliance and

ensures that the two HA NSX Edge virtual machines are not on the same ESX host even after you use DRS

and vMotion. Two virtual machines are deployed on vCenter in the same resource pool and datastore as the

appliance you configured. Local link IPs are assigned to HA virtual machines in the NSX Edge HA so that

they can communicate with each other. You can specify management IP addresses to override the local

links.

Procedure

1 Type the period in seconds within which, if the backup appliance does not receive a heartbeat signal

from the primary appliance, the primary appliance is considered inactive and the back up appliance

takes over. The default interval is 15 seconds.

2 (Optional) Type two management IP addresses in CIDR format to override the local link IPs assigned to

the HA virtual machines.

Ensure that the management IP addresses do not overlap with the IPs used for any other interface and

do not interfere with traffic routing. You should not use an IP that exists somewhere else on your

network, even if that network is not directly attached to the NSX Edge.

3 Click Next.

Confirm Settings and Install the Logical Router

Before you install the NSX Edge router, review the settings you entered.

Procedure

1 On the Summary page, review the settings for the NSX Edge.

2 Click Previous to modify the settings

3 Click Finish to accept the settings and install theNSX Edge router.

The logical router control virtual machine is deployed. Logical router instances are instantiated on each host

that has the logical switches being routed.

Chapter 4 Installing NSX Components

VMware, Inc. 35

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 57 58

Nessun commento

Upgrading everyday security Commpact Manuale Utente Pagina 35